Facing Russian steam Talkohlorit for furnaces Hephaestus PB-02 (ZK)
- In Stock
- Ex Tax: 3,420.20 руб.
- Brand: ООО "Технолит"
- Product Code: Русский пар 1300/50 Талькохлорит ПБ-02-ЗК
Facing approaches Hephaestus PB-02, PB-02M, PB-02P, PB-02-ZK, PB-02M-ZK, PB-02P-ZK
The main role of the cladding made of natural stone is the creation in the steam bath of the Russian bath. Facing in combination with the stove will ensure the correct bath conditions, will not allow to dry the steam room and will provide a lot of quality finely divided light vapor. And of course it will be the main decoration in the steam room. The company Svarozic produces for the cast-iron bath furnaces Gefest line of Classic, Lux / President and Russian steam cladding.
Wet steam in a Russian steam room undergoes extensive testing of a bath-cast iron stove and its lining in long-term operation. High humidity with extreme temperature changes is detrimental to the brick structure and leads to destruction in the near future. Natural stone as a facing furnace is considered a good alternative for its durability in long-term operation and efficiency. Talcochlorite or coil advantageously differs from masonry with cement mortar properties. Natural stone in the lining provides a much higher rate of heating to the desired temperature without the need for many hours of preparation of the furnace. Already after an hour or so the design under natural stone gives good steam and sufficient temperature.
The assembly of the slab in the natural stone cladding is performed according to the "groove-comb" scheme with the connection by means of a metal insert. Expansion under the influence of high temperatures occurs in every single detail. In masonry, the whole structure is deformed when heated and in the near future, at least minor repairs are required. Also, natural stone is distinguished by increased heat conductivity in operation.
To achieve the effect of a Russian steam bath oven is added to a special design when assembling. Below is a small gap for penetration inside, the rest of the furnace is tightly covered with a stone. At the top there is a hole with a door for leverage. As the convection ribs pass from below upwards, the air in the furnace heats up to a high temperature and leaves the structure through an open door in a constant circulation mode. Heat penetrates into the room with a constant steam flow and provides rapid heating for only one hour or more. After heating the air to a value of 50C, you can get a light finely divided pair, for this it is sufficient to push into the upper opening with the door open. After that, the door closes to prevent convection of air with the preservation of wet steam in the room.
Heating the temperature in the steam room with a natural stone is performed significantly faster and better in comparison with brickwork. Also this material provides high strength and durability in operation.
|Technical characteristics of cladding|
|Cladding height||1120/1300 mm|